Part 1: Spraying on the Cleaning Solution
1. Choose the right Chemical Solution
Consult the instructions for use for the cleaning solution and see whether it is safe for use with a pressure washer and even when you have used bleach. A few of the washers allow for the installation of a compartment where soaps and detergents are placed. For more information on siding solutions and maintenance, visit https://solidkansascitysiding.com/
Rewrite
2. Start with Low Pressure
First start with a low pressure of 1,300 – 1,600 PSI to determine the impacts of pressure on the vinyl siding.
3. Increase Pressure Gradually
Increase the nozzle for a little power as the surface requires or move closer to the surface.
4. Test on a Small Section
Start at a corner and ensure that you hold the nozzle steady to scrub out any grime and then work around the rest of the house.
5. Use Smooth, Sweeping Motions
Clean in straight up and down motions, sideways and diagonal but not circular or irregular to avoid smudging grime.
6. Work in Sections
The one has to clean one 2–3-foot-wide strip at a time intending to avoid hasty, careless cleaning and notice if the leaves are stained green or blue.
7. Angle the Nozzle Downward
Exit the water stream either parallel in connection with the siding or a little lowered to avoid the penetration of water behind the siding. Avoid spraying upward.
8. Allow the Solution to Work
Allow it to remain perhaps for 5-10 minutes to enable it to soften dirt before rinsing well.
Part 2: Preparing Your Work Area
1. Wear the necessary safety gear If you want to be safer, it is advisable to use a ventilated breathing mask or respirator If you operate a pressure washer, you must look for a good pair of work gloves any time you are operating the pressure washer.
2. It is necessary to temporarily take away or turn away objects which are nearby. All furniture nearby should be relocated temporarily to avoid getting wet or dirty by water and other particles.
3. Any part of the electrical system that can be seen should be protected. For that reason, to guard against shorts and other incidents you would not like any moisture to penetrate any of the outdoor electrical outlets or ports in your house.
4. Do not use a pressure washer to clean mould and mildew, always scrub off the surface by hand. Dilute one part of the normal household bleach with ten parts of water and pour into a spray bottle
Part 3 – clean
1. Pump the cleaning solution tank to drain the solution out. First of all, do not start rinsing before you wash off the detergent to make sure that you are running water through the pressure washer.
2. Switch to a lower pressure. In order not to apply any more pressure on the vinyl, set the pressure level between the range of 1,000 and 1,200.
3. Wash the siding from the top of the house down to the lowest part of the exterior façade. This time you will need to work from the opposite direction to ensure the soap is washing on the outside. Otherwise, it is possible to leave the streak.
4. Allow the siding to air dry
Part 4: Maintaining Vinyl Siding
1. Another suggestion is to clean your vinyl siding often. It is recommended to pay attention to the exterior of your home at least once every two years.
2. Scrub the siding manually during the interim and apply a touch of paint now and then. Non-porous surfaces should be washed with a mild bleach solution regularly to avoid day-to-day accumulation going rampant.
3. Check for wear and tear on the parts of the machine. Each clean should be preceded and followed by a 360 assessment.
Solid Kansas City Siding
107 W 9th St 2nd floor #585, Kansas City, MO 64105, USA
816-542-4147
